Product Manual

X-Sections Template Properties Window
MAGNET Tools ver 1.0
141
General Tab of the Properties / Add
Offset / Insert Offset Window
You can open this tab after selecting the Properties command from
the pop-up menu for the highlighted line in the right panel of the X-
Section Template tab. This tab contains data for the offset(s) of the X-
Section Template in the fields:
• Name
- the name of the offset. You can edit the name and leave
the field empty.
• Order
– the order of the offset in the template. You can set any
number from the list of offset numbers.
• Hz. Dist
– the horizontal offset (in the current linear units) from
the center line for the offset. You can edit the value.
• V.Dist
– the vertical offset from the horizontal plane for the
offset. You can edit the value. When you enter this parameter, the
Grade
will be automatically calculated.
• Grade
– the ratio of horizontal offset (Hz. Dist) and vertical offset
(V.Dist
) multiplied by 100%. When you enter this parameter, the
V.Dist
will be automatically calculated.
• Hz. Offset from CL (m)
– the horizontal offset from the center
line for the start point of the given offset. It is calculated using the
corresponding values of the previous offset(s) and it is not
editable.
• V. offset from CL (m)
– the vertical offset from the horizontal
plane for the start point of the offset. It is calculated using the
corresponding values of the previous offset(s) and it is not
editable.