Product Manual

Surface Properties Window
MAGNET Tools ver 1.0
115
Properties Window: End Position Tab
for a Segment
You can open this tab, after the Properties command from the pop-
up menu for the chosen segment in the Map View is selected. This tab
contains the coordinates of the end point (vertex) of the segment. You
cannot edit these values:
• End Northing
- the end point northing coordinate in the Ground /
Grid coordinate system.
• End Easting
– the end point easting coordinate in the Ground /
Grid coordinate system.
• End Azimuth
– the azimuth of the tangent to the given point
(vertex) for the current segment. You cannot edit this value.
Surface Properties Window
The Properties window for the surface which was created from points
and/or lines (not converted from roads and lines) contains the
following tabs: