Product Manual

Properties Window
MAGNET Tools ver 1.0
108
Properties Window: Adjustment Tab
for a DL Observation (Right Panel of
the DL Obs Tab)
You can open this tab after the Properties command from the pop-up
menu for the highlighted line in the right panel of the DL Obs tab is
selected.
This tab contains the fields:
• AutoReject
- In this field you can select the status of the given
DL observation for Adjustment:
- Allowed - the DL observation will be used in Adjustment.
- Not Allowed - the DL observation will not be used in
Adjustment.
• Adjustment Status
- the status of the given DL observation after
Adjustment:
- Not Adjusted - the DL observation is not adjusted.
- Adjusted - the DL observation is adjusted.
- AutoRejected - the DL observation is not adjusted because
the vector had the status Not Allowed before the adjustment
procedure.
- Disable - the DL observation is not adjusted because the
vector was disabled before the adjustment procedure.
• Ht. Residual
– adjustment residuals for the level
measurements.You cannot edit the value.
• Elevation
- the elevation on the FS point that includes the
elevation of sight and rod reading on the FS point. You cannot
edit the value.