Product Manual

Properties Window
MAGNET Tools ver 1.0
98
and check box:
Enabled
- if this check box is selected (default setting for the TS
observation), the given TS observation is included in adjustment,
coordinate calculation and export. If this parameter is unchecked,
adjustment, coordinate calculation and export will ignore the TS
observation(s).
Properties Window: Observation Tab
for a TS Observation (Right Panel of
the TS Obs Tab)
You can open this tab after selecting the Properties command from
the pop-up menu for the highlighted line in the right panel of the TS
Obs tab. This tab contains the fields:
• Point To
- the name of the point at which the reflector was set.
You can set any point's name from the list.
• Type
- the current type of the Total Station observation. This field
contains the list of the Total Station observation types. You can
select the other type for some types (not for all types). Click here
for more details.
• Reflector Height
- the vertical distance from the Reflector Center
Mark to the ground in the current linear units. To edit the value,
click on the highlighted field and enter a new value.
• Azimuth
- the azimuth value that defines orientation of TS
measurements by backsight from the station in the horizontal
plane. The field displays non-zero values only for BKB type. If
you set a point as backsight in the field, the azimuth value was
obtained by computation using the coordinates of the station
point and the backsight point. In this case, you cannot edit the
azimuth value. In the field, if you set an azimuth as backsight,
you directly entered the azimuth value. In this case, you can edit
the azimuth value in the software.
NOTE: The software allows
you to edit the azimuth value for BKB observation type only if
the Point To
field is empty.