Product Manual

6. BASIC OPERATION

When the instrument system detects a shock, this

function informs the operator of it.

• When the instrument’s installation status (height)

is sharply changed by the contact of the operator

or the like, this function stops auto leveling to

keep the operation accuracy and informs the

operator of the situation.

• After 10 minutes has passed since the auto

leveling function was activated and the laser

beam was emitted, this function works.

• The height alert function will not operate while setting the dual axes grade in the Matching

Mode, or Manual Mode.

$ Height Alert ON/OFFCHeight Alert ON/OFF (p. 49)

 How to reset

Turn off the power switch.

2 Check whether the instrument is installed correctly.

3 Turn on the power switch. Auto leveling starts again. After auto leveling is finished, the

laser beam is emitted.

4 Make sure that the laser beam is set at the correct height. Then, restart the operation.

6.2 Height Alert Function

Shock is given to the instrument.

Height Alert Display

(Flashing)