User manual

9Twintalker 9500 (RC-6406) Airsoft Edition
ENGLISH
13.10.3 Scanning for a DCS code
• Press the -button
7
seven times :
"SCAN" and "DCS 00"
flashes on the
display for the selected radio channel.
• Press the
-button
11
or the -
button
10
to start the DCS scan.
Once there is a transmission on the channel, the DCS code (if used) w
ill
be detected and displayed.
If you press the
PTT
button
12
while listening to a
found DCS code, the PMR will go back in stand-by mode
on
the channel with the DCS code.
13.11 Call Tones
A call tone alerts others that you want to start talking.
13.11.1
Setting the Call Tone
The Twintalker 9500 (RC-6406) has 15 call tones.
• Press the - button
7
eight times,
“C” is displayed
and the current call tone
is flashing.
• Press the
- button
11
or the -
button
10
to change to another Call
Tone.
• Press the
PTT
- button
12
to confirm
and return to stand-by mode.
13.11.2
Sending a call Tone
Press the button
6
briefly. The call tone will be transmitted on the
set channel.
13.11.3
Call tone reception type
• Press the -button
7
nine times.
• Press the
-button
11
or -button
10
to select the call tone
reception type.
1. Tone only
2. Tone + vibration
3. Vibration only
Press the
PTT
-button
12
to confirm and return to stand-by mode.
13.12 Roger Beep On/Off
After the
PTT
-button
12
is released, the unit will send out a roger beep
to confirm that you have stopped talking.
To set the Roger Beep.
•Press the
- button
7
ten times. ‘rO’ will be
displayed.
•Press
button
11
to enable (ON) or
button
10
to disable the Roger-Beep (OFF).
•Press the
PTT
- button
12
to confirm your
selection and return to the standby mode.
13.13 Key-Tone On/Off
When a button is pressed, the unit will beep briefly.
To set the key-tone.
•Press
button
7
eleven times. ‘tO’ will be
displayed.
•Press
button
11
to enable (ON) or
button
10
to disable the Key Tones (OFF).
•Press the
PTT
- button
12
to confirm your
selection and return to the standby mode.
13.14 Dual Channel Monitor function
In stand-by, the PMR is set on one channel with CTCSS/DCS code. The
PMR will only receive signals transmitted on that channel with the
CTCSS/DCS code.