User guide

5
Babytalker 3100
ENGLISH
7.1 Baby Unit Components
See Figure on the fold-out page.
7.2 Parent Unit Components
See Figure on the fold-out page.
8 Initial use
8.1 Package Contents
The equipment is supplied as standard with the following items:
8.2 Installing Batteries in the Baby Unit
See Figure on the fold-out page.
– Rotate the belt clip upward.
– Turn the screw on the cover of the battery compartment at the back of the baby
unit 90° counterclockwise and remove the battery compartment cover.
– Fit three AA alkaline cells (LR06/Mignon) in the battery compartment.
Ensure that the polarity is correct.
– Close the battery compartment.
1 Night light
2 Power LED
3 Night light button
4 On/Off switch
5 Paging button
6 Microphone
7 Battery cover closing screw
8 Connector for AC mains adapter
9 Fixing clips
10 NEMO radiation switch
11 Volume LEDs
12 Loudspeaker
13 Link LED
14 Increase volume
15 On/Off switch
16 Decrease volume / Previous menu
item
17 Power LED
18 Belt/wall fastening clip
19 Battery compartment cover
20 Charging indicator
21 AC mains adapter
- 1 baby unit
- 1 parent unit
- 1 charging station
- 2 AC mains adapters
- 1 user guide
- 1 service card
- 1 NiMH rechargeable battery pack
• You can operate the baby unit with three AA cells (LR06/Mignon; we recommend alkaline
cells) or the included AC mains adapter.
• The baby unit cannot recharge batteries.
• It is recommended to always leave the batteries in the unit, even if you use the AC mains
adapter. The unit will automatically switch to battery power in case of a mains power
interruption.
• Do not turn the screw past the ‘Open’ point.
• Never mix used cells with fresh cells.
A
B
A
90° MA
OPEN
9
7
SEDS
LONG
ECO
6V/300mA
+
+
+
+
-
AA x 1
+
-
AA
x 1
+
-
A
A
x 1