User guide

22
Troubleshooting
Command mode or during playback:
Turning on/off your answering machine from remote
During remote operation:
11 Troubleshooting
1 Press ‘1’ to replay the message.
2 Press ‘2’ to play all messages.
3 Press ‘3’ to skip to the next messages.
4 Press ‘6’ to delete the current message.
5 Press ‘8’ to stop playback.
1 Press ‘7’ to turn ON.
2 Press ‘9’ to turn OFF
Symptom Possible cause Solution
No display Batteries uncharged Check the position of the batteries
Recharge the batteries
Handset turned off Turn on the handset
No tone Telephone cord badly connected Check the telephone cord
connection
The line is occupied by another
handset
Wait until the other handset hangs
up
The icon flashes Handset out of range Bring the handset closer to the base
The base has no power supply Check the mains connection to the
base
The handset is not registered on
the base
Register the handset on the base
Base or handset do not
ring
The ringing volume is off or low Adjust the ringing volume
Not possible to transfer a
call on PABX
The flash time is too short or too
long
Change the flash time
Telephone does not react
when pressing the keys
Manipulation error Remove the batteries and put them
back in place