User guide

9
ENGLISH
TOPCOM BPM Wrist 3500
10.2 Procedure
• Press the START/STOP button to activate the device. All segments
will be displayed.
• Once the actual Memory zone is displayed (U1-3), press the MEMORY
button to select the desired memory zone.
• Press the START/STOP button to start measurement. If no button is
pressed within 5 seconds, the measurement will start automatically.
• The display will show the last measurement result before inflating the cuff
to the level that is right for you.
• When the right level is reached, the cuff will deflate.
This monitor will re-inflate automatically to approximately 220mmHg if the
system detects that your body needs more pressure to measure your blood
pressure.
• When the measurement is completed, systolic, diastolic and pulse will be
shown simultaneously on the LCD screen.
• When a mistake was detected during measurement the Error icon ‘EE’
appears on the display
10.3 Memory
The BPM Wrist 3500 has 3 Memory zones. Each can store up to 40
measurements including the date and time
The result will be stored automatically in the selected Memory Zone after the
measurement.
To recall measurement results:
When the clock is displayed:
• Press the MEMORY button to enter memory mode.
• Press the START/STOP button select the desired memory zone.
• Press the MEMORY button to see the last measurement result.
• Press the MEMORY button repeatedly for prior values stored.
• After the oldest record is displayed, the unit will switch back to normal time.
To erase all data from one memory zone:
• Press the MEMORY button to enter memory mode.
• Press the START/STOP button select the desired memory zone.
• Press the MEMORY button to see the last measurement result.
• Press and hold the MEMORY button for 3 seconds to erase all
records from the selected memory zone.