logo Standing hair dryer User Manual Packing List： Main body（Include telescopic rod） Base(Include Power supply cord） Remote controller User manual 1 set 1 set 1 set 1 set This user manual is applicable to B1D product model. Please read this manual carefully and keep it properly before using the product.
CAUTIONS AND NOTE This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances, especially when children are present, basic safety precautions should always be followed, including the following: interference,and (2) this device must accept any interference received, including interference that may cause undesired operation. READ ALL INSTRUCTIONS BEFORE USING DANGER – To reduce the risk of electrocution: 1.Always unplug this appliance immediately after using. 2.Do not use while bathing. 3.
MAINTENANCE AND SERVICE Make sure the on-off switch is off and unplug the power plug when cleaning the hair dryer. Please regularly use towel, cotton swab or toothbrush to remove the attachment of air inlet and outlet regularly. Do not press or rub the air inlet and outlet with nails or sharp objects to avoid damaging the product. Do not use alcohol, nail washing water or detergent to clean this product, otherwise it may cause failure, cracking or fading.
In case of abnormality or failure In case of abnormality or failure, such as no air, frequent stop, internal redness and smoke, please stop using immediately, unplug the power plug and call the company's service phone. In this case, the use of this product may cause electric shock, injury or fire due to short circuit. NOTE Operation instructions In the process of using,the air outlet and nozzle may become hot. Do not touch them with your hands, otherwise they may cause burns.
INSTALLATION GUIDE 1、installation. 2、Insert the power plug into the socket. 3、 Adjust the angle of the hair dryer head according to the rotation direction shown in the figure. √ 180° 4、 Adjust the height of supporting rod. 2 Turn until well connected 5、Press the power button ①， you will hear a beep. Quickly double click on-off button ②，the hair dr yer is on. 1 1 Insert 2 6、Use the four buttons on the outer ring of remote control to adjust the hair dryer.
PRODUCT INTRODUCTION Remote controller （Magnetic attraction） ON/OFF Decrease temperature Increase temperature Cool Supporting rod Hot OFF 3 speed Cool-hot recycling Back up Upper air outlet Lower air outlet Air inlet Indicator light Remote controller Main Body Base Power supply cord This symbol represents“Do not use this device in a bathtub,shower,or water-filled reservoir”。 DETAILED INSTRUCTIONS FOR REMOTE CONTROL 5 Grades 5 grades temperature light indicator Cool Hot Cool-hot recyclin
ABNORMAL STATUS OPERATION GUIDE INSTRUCTION FOR BACK UP BUTTON If the remote controller does not work,the back up button can be used to start the hair dryer in emergancy. Double click back up button to start , it goes directly into Hot Mode, then click, it goes into Cool Mode, next click ,it will be off. 【Hot】 【Cool】 【Power off】 REMOTE CONTROLLER RE-CONNECT Please re-connect the remote controller if the product is under following situation: 1.
