Users Manual

the MAC, through the digital and analog baseband, and finally to the RF chip.
Several special packets are initiated by the MAC. These are the only ways the digital
baseband portion will turn on the RF transmitter, which it then turns off at the end of
the packet. Therefore, the transmitter will be on only while one of the
aforementioned packets is being transmitted. In other words, this device
automatically discontinue transmission in case of either absence of information to
transmit or operational failure.
La transmission des données est toujours initiée par le logiciel, puis les données
sont transmises par l'intermédiaire du MAC, par la bande de base numérique et
analogique et, enfin, à la puce RF. Plusieurs paquets spéciaux sont initiés par le
MAC. Ce sont les seuls moyens pour qu'une partie de la bande de base numérique
active l'émetteur RF, puis désactive celui-ci à la fin du paquet. En conséquence,
l'émetteur reste uniquement activé lors de la transmission d'un des paquets
susmentionnés. En d'autres termes, ce dispositif interrompt automatiquement toute
transmission en cas d'absence d'information à transmettre ou de défaillance.
[§15.105 Information to the user.]
For a Class B digital device or peripheral, the instructions furnished the user shall
include the following or similar statement, placed in a prominent location in the text
of the manual:
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.