User Manual

1. Please take off the propeller set from the package. Disassemble the spinner by screw driver.
2. Please install the assembled propeller to the motor shaft.
3. Lock the propeller by wrench.
4. Assemble the spinner.
5. Lock the spinner by the screw driver.
6. Assembly of propeller is finished.
Securely tightening the nut will clamp the adaptor to the motor shaft and fix the propeller in position. Note: Use
of excessive force will cause damage to the aluminium adaptor.
Attach the front section of the plastic spinner and secure with the two screws provided.
Note: It is essential that the propeller is securely fixed. Failure to do so could result in
serious injury.
9. Receiver Installation
Connect the speed controller to the throttle channel of your receiver, (not included). This wire is easily
identified, it is the only one that is routed from the front of the model.
Connect the rudder and elevator servos to the corresponding channel outputs of the receiver and connect the
plug from the aileron “Y” lead to the aileron channel output. There is a moulded recess in this compartment
which is sufficient to accommodate most popular 2.4GHz receivers; however there is ample room elsewhere to
locate yours if it does not.
We recommend that it should be securely positioned with self-adhesive “Velcro”.
You must adhere to the receiver manufacturer recommendations regarding positioning and aerial routing.
8. Propeller & Spinner