User Manual

2xScrew2.6x35mm
4. Tail-Plane Fixing
Fix the horizontal tail-plane and vertical fin in position
with the two 2.6 x 35mm screws provided, (imageD).
The screws must be tightened sufficiently to securely
fix the parts in position, however be careful not to
over-tighten the screws.
6. Wing Assembly
Locate the 500mm aluminium wing joining spar and
slide into the round aperture of one wing panel up to
the centre locating collar. Locate the small plywood
wing locking plate and insert into the rectangular
aperture behind the main wing spar, (image G). Slide
the remaining wing panel onto the exposed portion
of the aluminium spar. The plywood locking plate will
ensure perfect alignment of the two wing halves. Be
certain that all wires are routed correctly via the
moulded slots and do not foul the joint between the
wing roots. If desired, a small amount of foam glue
can be used for maximum security.
5. Tail Control Horns
Connect the rudder and elevator snap-links to their respective control horns as shown in images E&F.
Minor adjustment to obtain perfect neutral positions of the control surfaces can be achieved by rotating the
plastic link on the threaded portion of the control push-rod.
Make certain the plastic link is securely “snapped” closed when connected to the control horn.