User Manual

Assembly instructions
1. Undercarriage
Fix the undercarriage in position with the four 2.6 x
12mm self-tapping screws as shown, (image A). If the
screws become excessively tight whilst fixing, simply
back them off a turn or two, and then continue.
Note: The undercarriage legs are angled towards
the front of the fuselage.
4 x Screw 2.6 x 12mm
2. Horizontal Tail-Plane
Remove the moulded tab at the end of the fuselage with a sharp knife. Slide the horizontal tail- plane into the
fuselage slot as shown, (image B). Make certain that the holes in the tail-plane lineup with the corresponding
fuselage holes. If desired, a small amount of foam glue can be used for maximum security.
3. Vertical Fin & Rudder
Install the vertical fin and rudder assembly
into the slot in the fuselage. Please make
certain that the tail-wheel control wire is
located correctly in the rudder slot as shown,
(image C).
If desired, a small amount of foam glue can
be used for maximum security.
Note:Tail wheel wire needs to
be inserted the plastic hole of
the rudder.