Operation Manual
CONTENTS Brief introduction...................................................................................................1 Main specifications................................................................................................1 Main configuration................................................................................................1 Products constitution............................................................................................1 Assemble processes..................
Brief Introduction Thank you for purchasing our T1800 glider from Top RC Hobby , and we hope this plane will bring endless joy to you after you choose it. ★It is very easy to assemble in several minutes and the wings are removable, very easy to carry and maintain. ★Both the wings and fuselage are reinforced with 9.0MM aluminum tubes to improve the flight strength of the entire flight.
Assemble processes 1. Please take out the fuselage, horizontal wing, accessories bag and then connect the servo plug on the horizontal wing with fuselage servo cable socket, and use PM2*16MM screws to install the horizontal wing on the vertical wing of the fuselage and fix it firmly. 2.
Adjustment steps 1. Turn on the transmitter and please make sure that there is enough power for the transmitter. Push the joystick of the throttle and throttle trim switch to the lowest position, and keep other trim switch be in the neutral position. 2. Please connect the battery to the ESC plug, and put the battery into the battery case well, than close the battery cover. 3.
5. Check the position of the center of gravity of the flight to ensure that the position of the center of gravity is within the range shown in the below picture. 65~72mm 6. Finished the adjustment of T1800.
Safety precautions 1.If you have the simulator, we suggest that you can practise your skill by the simulator before you fly this model, which will bring some help for you. 2.Please climb the plane above the 50 meters with half throttle to fly it when you fly it for your first time, then you will be familiar with the performance of this plane. 3.You should learn how to control this model blandly, it will reduce the possibility of crash and prolong the usage life of the plane. 4.
Notice 1.Be fully charged under no more than 1 A voltage by using the specified charger. 2.Be discharged under 10C voltage but avoiding discharge time too long to harm the battery. 3.Repeat the first and second step one or two times. 4.When the Li-poly battery was stored more than 3 months, it needs to be recharged to maintain its voltage, and ensure its life time. Safety Instruction of Li-Po/Ni-MH battery 1. Do not disassemble or reconstruct the battery. 2. Do not short-circuit the battery. 3.
Trouble shooting Problem Possible Cause Solution Aircraft will not respond to the throttlebut responds to other controls. -ESC is not armed. -Throttle channel is reversed. -Lower throttle stick and throttle trim to lowest settings. -Reverse throttle channel on transmitter. Extra propeller noise or extra vibration. -Damaged spinner, propeller, motor or motor mount. -Loose propeller and spinner parts. -Propellor installed backwards. -Replace damaged parts.
Trouble shooting guide Strict ground inspections must be done before each flight, which can effectively avoid flight accidents. 1. Check if the screws of the whole airplane are installed in place or not, the servo arms and horns are connected reliable or not and wings fixing are locked or not. 2. Install the battery and adjust the aircraft's center of gravity to the recommended position in the manual. 3. Make sure power battery, remote control transmitter battery, etc.
配件部分 No:TOP09109 Adapter for propeller No:TOP20401 40A Brushless ESC No:TOP30201 9g servo(plastic gear) No:TOP40602 Out runner brushless 1150KV No:TOP09103 Wing Connecting Rod No:TOP09104 Wing Screw 9
www.toprchobby.
