MODEL SF-680 Digital Fabric Steam Press by Top Innovations, Inc. Please read all instructions before use. Mail in your warranty registration card.
LETTER FROM THE CEO Dear Valued Customer, Congratulations on purchasing your new Digital Fabric Steam Press. This powerful new product is designed to give your garments a clean, wrinkle-free, ironed look without the hassle of using a conventional iron. Turn your Digital Fabric Steam Press on, and in minutes, you are ready to delicately remove wrinkles from garments, and restore crisp, long-lasting creases.
IMPORTANT SAFEGUARDS WARNING: To reduce the risk of fire, electrical shock, or injury, the following basic safety precautions should always be followed when using an electrical appliance. READ ALL INSTRUCTIONS BEFORE USING YOUR STEAM PRESS 1. DO NOT leave your SF-680 Digital Fabric Steam Press unattended when plugged in or not in use. 2. This unit is not a toy. Close supervision is required when using unit near children, pets, and plants. Unit produces steam that is hot and pressurized.
IMPORTANT SAFEGUARDS WARNING: To reduce the risk of electric shock, this appliance has a three-pronged plug. This plug will fit in a polarized wall outlet only one way. If the plug does not fit fully in the outlet, contact a licensed electrician to install a proper outlet. DO NOT attempt to modify the plug or defeat this safety feature. 8. DO NOT handle or use this unit while hands are wet or when not wearing shoes.
DIGITAL FABRIC STEAM PRESS PRODUCT INFORMATION The following features and accessories are included with your steam press. Carefully inspect packaging material as some parts are shipped inside Styrofoam packaging. To obtain possible missing parts, refer to the Customer Support section on page 10 of this manual. UNIT FEATURES AND ACCESSORIES 1. Handle 2. Steam Burst Buttons 3a. Water Reservoir Cap 3b. Water Reservoir 4. Ironing Board 5. Pressing Plate 6. Pressing Plate Cover 7. On/Off Switch 8.
DIGITAL FABRIC STEAM PRESS PRODUCT INFORMATION - The Handle (1) is used to safely lift up and lower the Pressing Plate, and carry the unit. - The Steam Burst Buttons (2) are located on either side of the Handle, and produce a powerful burst of steam when pressed. - The Water Reservoir Cap (3a) covers the Water Reservoir fill hole and must be removed in order to fill the Water Reservoir with distilled water. - The Water Reservoir (3b) is the tank in which distilled water is stored for use by the unit.
USING THE DIGITAL FABRIC STEAM PRESS FILLING WATER RESERVOIR 1. Place Digital Fabric Steam Press on a flat, level surface. 2. Turn Locking Knob to “Unlock” position to unlock Pressing Plate. 3. Lift up Pressing Plate using Handle. It will automatically stay in lifted position. 4. Pull Water Reservoir out. Note that Water Reservoir cannot be completely removed from unit; do not attempt to force it free. 5. Remove Water Reservoir Cap to expose Water Reservoir fill hole. 6.
USING THE DIGITAL FABRIC STEAM PRESS STEAM BURST 1. Hold Pressing Plate approximately 3” above Ironing Board. 2. Press Steam Burst Button to release a burst of steam onto fabric. 3. Lower Pressing Plate onto fabric, then raise once again. 4. Repeat steps 1-3 above until fabric is smooth and wrinkle-free. PRESSING AND STEAMING TIPS Pressing Shirts and Blouses 1. Place shoulder yoke on Ironing Board first and press. 2. Next, place sleeves onto Ironing Board with fold parallel to long seam and press. 3.
CARE AND STORAGE GUIDELINES AUTO SHUT-OFF The Auto Shut-Off feature of the Digital Fabric Steam Press includes both an Auto Shut-Off and an Auto Wake-Up. These multiple function safety features deactivate electrical power to the heater when the Pressing Plate has been left in closed position against the Ironing Board for more than 10 seconds. Heater deactivation is signaled by a beeping sound. Heater functionality is restored when the Pressing Plate is lifted back up.
CUSTOMER SUPPORT PROBLEM SOLUTION POSSIBLE CAUSE Unit fails to steam. Power Indicator Light does not illuminate. Unit fails to steam. Power Indicator Light does illuminate. Steam Burst output is weak or intermittent. Unit is not plugged in. Plug into electrical outlet. Household Circuit Breaker / Ground Fault Interrupter has tripped or blown a fuse. Reset Circuit Breaker / Ground Fault Interrupter, or replace fuse. If you need assistance, contact a licensed electrician. Auto Shut-Off has engaged.
WARRANTY INFORMATION ONE YEAR LIMITED WARRANTY (If outside USA, additional shipping charges may apply) Top Innovations, Inc. warrants this product to be free from defects in material and workmanship for a period of one (1) year from the date of purchase. This warranty does not cover damage caused by misuse, negligence, use by improper current or voltage, use contrary to operating instructions or disassembly, repair or alteration by any person other than Top Innovations, Inc. Warranty Service Department.
Top Innovations, Inc. 400 N.W. Platte Valley Dr. Riverside, MO 64150 Tel: (800) 711-6617 (816) 584-9700 www.topinnovations.com customerservice@topinnovations.
