- Top Innovations, Inc. Sewing Machine User Manual

9
6. Tie off the seam as follows:
a. Pass Threader through the last stitch.
b. Place the thread into Threader.
c. Pull out about 1 inch.
d. Slip the thread through the loop and pull it tight to
finish the seam.
10
How to Thread the HandyMender
Thread the HandyMender following the numbers as shown below.
NOTE: Thread should flow from
the bobbin or spool as shown:
(The spring must be in place
before installing bobbin.)
Use threader to pass the thread through needle eye from rear to
front.
Adjusting the Thread Tension
• If stitching is too tight, turn the tension control nut slightly to the
left
• If stitching is too loose, turn the tension control nut slightly to the
right