User Manual

❏

3. Apply the decals to both of the side panels.

❏

4. Insert the side panels and mark the outline on the

front and back of the cockpit. Remove the side panels. Use

a T-pin to prick holes in the top of the stringer. We applied

canopy glue to the cockpit  oor and the front and back of

the cockpit, inside the side panel outlines. This will allow the

side panels to be positioned and any excess glue wiped off

with a wet paper towel. We then used medium CA to glue

the top  ange on the stringer.

❏

5. Trim the armor plate/head rest as shown. Test  t the

armor plate in the fuselage and trim as needed. Roughen

the back of the armor plate and use medium CA to glue the

armor plate in the fuselage.