User Manual

41
S.Bus Setup: Connect the two 20" [500mm] S.Bus hubs
to a 12" [300mm] hub. This hub is plugged into the 6-Way
Terminal Box when the wing is installed.
Install the Belly Pan
Perform steps 1, 2 and 3 if the optional drop tank will
not be installed.
❏
1. Mount the wing on the fuselage. Make any adjustments
required to get a good  t between the wing and fuselage. This
may require some light sanding of the wing dowel holes in
the front of the fuselage. Position the belly pan on the wing
so that it is evenly spaced between the fuselage. Mark the
outline of the belly pan on the bottom of the wing. Carefully
cut and remove a 1/4" [6mm] wide strip of covering, 1/32"
[.8mm] from the inside of the outline.
❏
2. Remove the wing and place waxed paper between the
wing and the fuselage at the leading and trailing edge. This
will prevent the wing from becoming glued to the fuselage
if the epoxy should run out of the joint. Reinstall the wing.
❏
3. Glue the belly pan to the wing using 30-minute epoxy.
Make sure that the belly pan is tight against the bottom of
the wing and centered between the fuselage. Wipe off any
excess epoxy before it cures.
❏
4. If you will be installing the optional drop tank, trim the
covering from over the four bolt openings on the belly pan.
❏
5. Trim the covering from over the four corresponding
holes in the bottom of the wing.
❏
6. Test  t the belly pan on the wing, attaching it with four
¼" – 20 x 2" [51mm] nylon wing bolts included with the optional
drop tank. The instructions for the drop tank installation is
included with the drop tank.