User Manual

31
❏
12. Carefully study the following images and glue the
throttle/choke servo tray together as shown. The tray can be
assembled to  t on either side of the fuselage, depending
on which side the throttle and choke are on.
❏
13. Glue the throttle/choke servo tray in the slots in the
side of the fuselage.
❏
14. Install the throttle and choke servos in the servo tray.
Harden the screw holes with thin CA.
❏
15. Follow the setup diagram for your installation to connect
the throttle and choke to the receiver.
❏
16. To make a throttle pushrod, thread a 2-56 x 1" [ 25 mm ]
threaded rod completely into a nylon ball link socket. Trim
the threaded rod so that approximately 3/8" [9mm] of the
threaded rod remains. Thread the ball link socket and
threaded rod into the end of the white inner pushrod tube.
❏
17. Thread a second 2-56 x 1" [25mm] threaded rod 20
turns into a nylon clevis.