User Manual

27
❏
4. Install the motor mount on the RimFire 65 motor following
the instructions included with the XX-Large Stand Off Motor
Mount. The front of the drive washer should be 6-3/4" [171mm]
from the back of the stand offs.
❏
5. Follow the Stand Off Motor Mount instructions to install
the motor on the  rewall box. The RimFire 65 motor uses the
embossed ‘X’ pattern on the front of the  rewall box. Drill a
5/16" [8mm] hole at each mark.
❏
6. Assemble the ESC mount as shown. Drill 5/64" [2mm]
pilot holes through the doubler as shown.
❏
7. Position the ESC mount on the  rewall box and drill
four 5/64" [2mm] pilot holes through the  rewall box (two
on top and two in the front). Attach the ESC mount with #4
x ½" [13mm] sheet metal screws and #4  at washers. Apply
a drop of thin CA to harden the screw holes.