User Manual

22
❏
10. Place the tail gear in the fuselage while simultaneously
guiding the pull-pull cable through the white plastic guide
tubes. Also route the actuator extensions or air lines through
the fuselage.
❏
11. Drill four 3/32" [2.5mm] holes through the rails for
mounting the tail gear. If your drill bit is not long enough to
reach the rail nearest the top of the fuselage, use medium CA
to temporarily glue a 3/32" [2.5mm] drill bit in a 1/8" [3.2mm]
brass tube. After drilling the holes, the drill bit can be removed
from the tube by heating the tube.
INSTALL THE ELEVATOR
AND RUDDER SERVOS
❏
1. If you are installing pneumatic retracts, insert the
pressure tank in the fuselage. Apply a couple of dabs of
silicone glue to the joint between the tank and the former.
❏
2. Use thin CA to glue the 1/8" x 3/8" x 5-3/4" [3.2 x 9.5
x 146mm] plywood servo doublers to the bottom of the
servo tray.
❏
3. If you are installing pneumatic retracts, glue the pressure
tank retainer to the bottom of the servo tray.