User Manual

16
❏
7. Extend the landing gear and snap one of the landing
gear door mounts over the retract. Rotate the mount and
slide it up the strut past the pin.
❏
8. Install the second landing gear door mount and position
as shown.
❏
9. Retract the landing gear and position the landing gear
door over the strut. Center the door in the opening. Place a
piece of masking tape on each side of the retract. Mark the
position of the mounting holes on the tape.
❏
10. Use the 1/16" (1.5mm) plywood spacers to adjust
the height of the gear doors to match the bottom of the
wing. If one of the gear door mounts is too high, use 80 grit
sandpaper to sand the face of the mount. Once satis ed
with the height of the gear doors, glue the plywood spacers
to the gear door mounts.