operation manual

 www.scheppach.com /  [e-mail] /  +(49)-08223-4002-99 /  +(49)-08223-4002-58  www.scheppach.com /  [e-mail] /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
15GB
Training of the operator
• Forward the safety instructions to all people working on or with this machine.
• The minimum age for the operating person is 18 years. Trainees should be minimum 16 years of age, but are only
allowed to work with the machine under supervision.
• People running the machine should not be distracted.
• Keep children away from the to the net connected machine.
• Do not wear tight clothing. Take off jewelry, rings and wristwatches.
• Observe all safety and hazard warnings on the machine and keep it in readable condition.
• Be careful at work: Danger of damaging nger(s) and hand(s) by the rotating cutting tool.
• Regular pauses must be observed during operation.
• Safety shoes and protective clothing must be worn during operation.
Technical Data
Construction measurements
Total length mm 1270
Total width mm 730
Total height mm 1130
Rocker support mm 670
Saw blade ø mm 700
Idle speed motor 1/min 1400
Cutting speed saw blade m/sec 52
Weight kg 92
Power unit
Motor V/Hz 380 - 420 / 50
Input power P1 kW 5,2
Output power P2 kW 3,58
Operating mode S6 / 40%
Rated current A 10
Work information
Cutting height Spar max. mm 240
min. mm 60
Turning cut max. mm 250
Piece of wood max. mm 380x240
Reserve technical changes!
Specic noise values
The according to the EN 23746 for the sound pres-
sure level resp. EN 31202 (correction factor k3 after
supplement A.2 from EN 31204 calculated) for the
sound pressure level on the working site ascertained
noise emission value amounts under the foundations
of ISO 7904 supplement a performed working con-
ditions to
Sound pressure level in dB
Idle LwA / Processing LwA 95 / 102
Sound pressure level on wor-
king site in dB
Idle LqAeq / Processing LqAeq 85 / 92
The specied values are emission values and there-
fore should not at the same time be reliable working
site values. Although there is a correlation between
emission and immision levels, it cannot unfailingly be
derived if extra precautions need to be taken or not.
Factors, which inuence the actual availabe immusion
value on working site, include the peculiarities of work-
ing area, other sources of noise, e.g. the number of
machines and other adjoining processes. The allowed
working values could vary from country to country.
However, the information should qualify the user, to be
able to make an estimation of the dangers and risks.
Scope of delivery
• Rocker circular saw
• Allen key or open-end wrench
• Locking pin
• Operating instructions
Assembly
The machine is supplied completely assembled them,
and is therefore ready to use.
Setting-up and adjustment
• Please pay attention that your rocker circular saw is
set up stable and on a leveled oor.
• The workplace must be well lit.
• There should be no obstacles to the machine.