Growing God fie ser EERIE VER] Anon Hollie Vise Plate (URKReleaselavet WARNING! READ ALL INSTRUCTIONS Always check the safety regulations applicable i your Cody to FedEx the risk of the fire, electric shocking personal injury. Understand the following safety instructions before attempting ta operate this product. Keep these instructions. at a safe place. SAVE THESE INSTRUCTIONS Work Area seep your work area glean.
change the plug in any way. Double insulation eliminates the need for the three wire grounded prerecord and grounded power supply systems. sh void body contact with grounded surfaces such as pips, radiators; ranges refrigeration, There Nisan increased risk of electric shook Your body is grounded. wisdom expose post fools to rain:or wet conditions. Water anteing a power toh will increase he risk of electroshock.
Many accidents are caused by poorly maintained tools: Use only scoreless that arg recommended by the manufacturer for your model Accessories that are suitable morons tool may posit another check the size and fitting prior ise, Service «Tool service must be performed only by qualified repair personnel, Sen vice or maintenance performed by unqualified personnel cooed raga in a riskily injury «When servicing 4 tool, use only identical replacement parts.
~ Abrasive cut-off wheel Pen-end wrench instruction manual GROUNDING This tool has: a three-prong plug for proper grounding with grounded outlet If a temporary adapters used to connect to & two-prong outlet, the green ground tab of the adapter included must be conned fo par anent ground such asa properly grounded outlet box or grounding, call a qualified electrician. Do riot modify the fig provided.
7. Figure 3. Argus) pe blame. ; CHR RR Figured 8. Dressiness Hold the straight (4H wrench, the tight (clockwise) the outer fang withe curly (28) wrench, 4. Put the arbor cover back'to its original position and hands tighten wing puts, 1 tie Chisel guard revered, or usd foot Bis & grinder with the abrasive shew! exposed. Stitch usage may Always wear safety glasses or eye: shields when operating tools.
| | CAUTION? if any of the following | events ocelots during normal ! operation the power supply should ; tie concubine at once-and the fool thoroughly inspected by a qualified person and repaired if necessary: 1. The turning parts get stuck and low, 2. The Lull shakes abnormally accompanied by some: abnormal nose 3. Heavy sparks amour earthbound rotor ares. MAINTENANCE WARNING! Do nob allow brake fluids gasoline, pelican-based products penetrating ols, ste. come intercontinental plastic parts.
Quick Release Vise 1 Pull upon the quick release lever to allow free movement of the vise Note: when the vise ig closed Eight, release the tension by truing the vise handle in 2 sounder-clockwise direction before pulling up on the quick release lover. Move vise plate back to allow placement of work piece Position work piece push vise plate against it Reposition quick release lever and tum vise handle ina clockwise direction lo tighten vise. To remove work Pisces, repeat step t and 2 above.
