M7 Manual V1.0
Table Of Contents
- Introduction
- Key Points
- Further information
- Safety
- Contents
- M7 Layout
- Quick start
- Charge and discharge settings
- 1. Battery type setting
- 2. The Cells Setting
- 3. Work Mode
- 4. Discharge mode
- 5. Input MaxVoltage
- 6. End voltage setting (TVC)
- 7. Current setting
- 8. NiMh setting (PeakV)
- 9. Cycle setting
- 10. External load setting
- 11. Smart battery setting
- Charge and discharge work
- Accessibility
- 3. Signal output
- 4. ESC test
- 5. Power
- System settings
- Other functions
- Specifications
@ToolkiRC 2021
9
Quick start
1，Connect the 7-28V power supply to the input port on
the back of the M7.
2，The display shows the boot logo and stays for 2
seconds.
3，Simultaneously with do-re-mi boot sound.
4，After the boot is completed, the screen enters the
main interface and displays as follows:
5，Long press [Exit] to enter the auxiliary function
interface.
6，Scroll [Scroll Wheel] to switch the page below.
7，Short press [OK] to select the charging task when the
charger is idle. You can adjust and finish the work when
the charger is working.
8，Long press [OK] to enter the system setting interface