M7 Manual V1.0
Table Of Contents
- Introduction
- Key Points
- Further information
- Safety
- Contents
- M7 Layout
- Quick start
- Charge and discharge settings
- 1. Battery type setting
- 2. The Cells Setting
- 3. Work Mode
- 4. Discharge mode
- 5. Input MaxVoltage
- 6. End voltage setting (TVC)
- 7. Current setting
- 8. NiMh setting (PeakV)
- 9. Cycle setting
- 10. External load setting
- 11. Smart battery setting
- Charge and discharge work
- Accessibility
- 3. Signal output
- 4. ESC test
- 5. Power
- System settings
- Other functions
- Specifications
@ToolkiRC 2021
44
voltmeter value, and achieve calibration. After the
calibration is completed, move the cursor to save, short
press once, the buzzer will beep once, the save is
successful. Just exit or shut down
7, fully charged
When the lithium battery is fully charged, it will
prompt "Fast charge is done". If the battery is not
removed, the constant voltage trickle charge will be
performed automatically to make the battery reach a
more full state.