M7 Manual V1.0
Table Of Contents
- Introduction
- Key Points
- Further information
- Safety
- Contents
- M7 Layout
- Quick start
- Charge and discharge settings
- 1. Battery type setting
- 2. The Cells Setting
- 3. Work Mode
- 4. Discharge mode
- 5. Input MaxVoltage
- 6. End voltage setting (TVC)
- 7. Current setting
- 8. NiMh setting (PeakV)
- 9. Cycle setting
- 10. External load setting
- 11. Smart battery setting
- Charge and discharge work
- Accessibility
- 3. Signal output
- 4. ESC test
- 5. Power
- System settings
- Other functions
- Specifications
@ToolkiRC 2021
37
4. ESC test
Select ESC test with the cursor, short press [OK] to
enter the ESC test, scroll [Scroll wheel], move the cursor
to the pulse width and cycle, press [OK] to change the
corresponding value. As shown below:
5. Power
Select the adjustable power supply with the cursor,
and short press [OK] to enter the power.
The voltage and current of the output power
supply can be set. Move the cursor to the beginning,
short press [OK] to start power output and return to the
main interface. As shown below: