M7 Manual V1.0
Table Of Contents
- Introduction
- Key Points
- Further information
- Safety
- Contents
- M7 Layout
- Quick start
- Charge and discharge settings
- 1. Battery type setting
- 2. The Cells Setting
- 3. Work Mode
- 4. Discharge mode
- 5. Input MaxVoltage
- 6. End voltage setting (TVC)
- 7. Current setting
- 8. NiMh setting (PeakV)
- 9. Cycle setting
- 10. External load setting
- 11. Smart battery setting
- Charge and discharge work
- Accessibility
- 3. Signal output
- 4. ESC test
- 5. Power
- System settings
- Other functions
- Specifications
@ToolkiRC 2021
30
Accessibility
After selecting and long pressing [Exit] in the main
interface, you can enter the auxiliary function interface
when the charger is idle, as shown below:
1. Measure resistance
Short press [OK] to test the internal resistance of
the connected battery and return to the main interface
display.
2. Measure signal
The cursor selects the measure signal, short press
[OK] to enter the signal test interface.
Scroll [Scroll wheel] to select the type of signal to
be tested. Select PWM, as shown below: