M7 Manual V1.0
Table Of Contents
- Introduction
- Key Points
- Further information
- Safety
- Contents
- M7 Layout
- Quick start
- Charge and discharge settings
- 1. Battery type setting
- 2. The Cells Setting
- 3. Work Mode
- 4. Discharge mode
- 5. Input MaxVoltage
- 6. End voltage setting (TVC)
- 7. Current setting
- 8. NiMh setting (PeakV)
- 9. Cycle setting
- 10. External load setting
- 11. Smart battery setting
- Charge and discharge work
- Accessibility
- 3. Signal output
- 4. ESC test
- 5. Power
- System settings
- Other functions
- Specifications
@ToolkiRC 2021
25
Charge and discharge work
When charging and discharging starts, the charger
enters the working interface as shown below:
Rotate [Scroll Wheel] on this interface to switch the
bottom status information and internal resistance
voltage value. Short press [OK] to dynamically set the
working current or stop working. As shown below: