M7 Manual V1.0
Table Of Contents
- Introduction
- Key Points
- Further information
- Safety
- Contents
- M7 Layout
- Quick start
- Charge and discharge settings
- 1. Battery type setting
- 2. The Cells Setting
- 3. Work Mode
- 4. Discharge mode
- 5. Input MaxVoltage
- 6. End voltage setting (TVC)
- 7. Current setting
- 8. NiMh setting (PeakV)
- 9. Cycle setting
- 10. External load setting
- 11. Smart battery setting
- Charge and discharge work
- Accessibility
- 3. Signal output
- 4. ESC test
- 5. Power
- System settings
- Other functions
- Specifications
@ToolkiRC 2021
21
PeakV: When the nickel-metal hydride battery is fully
charged, the voltage drop of each piece peaks.
===================================
9. Cycle setting
When the battery type is NiMh, and the work
mode is cycle, the battery setting interface will increase
Cycle times and Rest time setting. As shown below:
Move the cursor to [Cycle times] and press [OK] to
set the range of cycle times to 2-12.
The charger will follow the pattern cycle of
discharge->charge->discharge->charge....
"Discharge -> charge" is 2 times.