M7 Manual V1.0
Table Of Contents
- Introduction
- Key Points
- Further information
- Safety
- Contents
- M7 Layout
- Quick start
- Charge and discharge settings
- 1. Battery type setting
- 2. The Cells Setting
- 3. Work Mode
- 4. Discharge mode
- 5. Input MaxVoltage
- 6. End voltage setting (TVC)
- 7. Current setting
- 8. NiMh setting (PeakV)
- 9. Cycle setting
- 10. External load setting
- 11. Smart battery setting
- Charge and discharge work
- Accessibility
- 3. Signal output
- 4. ESC test
- 5. Power
- System settings
- Other functions
- Specifications
@ToolkiRC 2021
16
4. Discharge mode
When the working mode selects discharge, storage,
and cycle mode, the battery setting interface will
increase the discharge mode.
Move the cursor to [Discharge Mode] and press [OK]
to modify the discharge mode, as shown below:
The charger supports three discharge modes.
1.
Normal mode: discharge through internal heat
consumption, maximum support 3.0A@10W discharge.
2. Recycle mode: when the input is battery power,
the power is recovered to the input battery through this
function, and the maximum support is 10.0A@200W
discharge.
3. External mode: when the input port is connected
to the discharge load and the output port is connected
to the battery, it can be discharged through this function,
and the maximum support 10.0A@200W discharge.