M7 Manual V1.0
Table Of Contents
- Introduction
- Key Points
- Further information
- Safety
- Contents
- M7 Layout
- Quick start
- Charge and discharge settings
- 1. Battery type setting
- 2. The Cells Setting
- 3. Work Mode
- 4. Discharge mode
- 5. Input MaxVoltage
- 6. End voltage setting (TVC)
- 7. Current setting
- 8. NiMh setting (PeakV)
- 9. Cycle setting
- 10. External load setting
- 11. Smart battery setting
- Charge and discharge work
- Accessibility
- 3. Signal output
- 4. ESC test
- 5. Power
- System settings
- Other functions
- Specifications
@ToolkiRC 2021
15
2. The Cells is set incorrectly, it may be
unsatisfactory, or overcharge may damage the battery,
please set it carefully.
3. After Lixx batteries are connected to the balance
port, the battery cells can be more accurately identified.
=================================
3. Work Mode
Move the cursor to [Mode] and press [OK] to
modify the work mode, as shown in the figure below:
Lipo, LiHV, LiFe, Lion batteries can be charged,
discharged, and stored. NiMh battery can choose to
charge, discharge, cycle. PB battery can choose to
charge and discharge. Short press [OK] and [Exit] to take
effect and return to the previous interface.