M6D Manual V1.0
Table Of Contents
- Introduction
- Key Points
- Further information
- Safety
- Contents
- M6D Layout
- Quick start
- Charge and discharge settings
- 1，Battery type
- 2，Number of cells
- 3，Mode
- 4，Discharge mode
- 5，Input MaxVoltage
- 6，End voltage（TVC）
- 7，Current setting
- 8，NiMH setting (PeakV)
- 9，Cycle setting
- 10，Power mode setting
- 11，Smart battery
- Charge and discharge work
- System settings
- other functions
- Specification
@ ToolkitRC 2020
9
Quick start
1，Connect a 7-28V power supply or input battery to
the input port on the back of the M6D.
2，The display shows the boot logo and stays for 2
seconds.
3，At the same time accompanied by do-re-mi's boot
sound.
4，After booting, the display will enter the main
interface and display as follows:
5，Short press [Exit], the cursor switches between the
left and right channels.
6，Press and hold [EXIT] to start testing the internal
resistance of the corresponding channel. After the test,
the internal resistance will be displayed.
7，Scroll [Scroll Wheel] to switch the pages in the