M6D Manual V1.0
Table Of Contents
- Introduction
- Key Points
- Further information
- Safety
- Contents
- M6D Layout
- Quick start
- Charge and discharge settings
- 1，Battery type
- 2，Number of cells
- 3，Mode
- 4，Discharge mode
- 5，Input MaxVoltage
- 6，End voltage（TVC）
- 7，Current setting
- 8，NiMH setting (PeakV)
- 9，Cycle setting
- 10，Power mode setting
- 11，Smart battery
- Charge and discharge work
- System settings
- other functions
- Specification
@ ToolkitRC 2020
22
9，Cycle setting
When the battery type is NiMh, and the work
mode is selected to cycle, the battery setting interface
will increase the number of cycles and the rest time
setting. As shown below.
Move the cursor to [Cycle times] and press [OK] to
set the cycle times to 2-12. The charger will follow the
pattern cycle of discharging-> charging->
discharging-> charging ... "Discharge-> Charge" is 2
times.