M6D Manual V1.0
Table Of Contents
- Introduction
- Key Points
- Further information
- Safety
- Contents
- M6D Layout
- Quick start
- Charge and discharge settings
- 1，Battery type
- 2，Number of cells
- 3，Mode
- 4，Discharge mode
- 5，Input MaxVoltage
- 6，End voltage（TVC）
- 7，Current setting
- 8，NiMH setting (PeakV)
- 9，Cycle setting
- 10，Power mode setting
- 11，Smart battery
- Charge and discharge work
- System settings
- other functions
- Specification
@ ToolkitRC 2020
21
in the corresponding working mode
3. For the setting of discharge mode, please refer to
the chapter of <System Settings> in this manual
===================================
8，NiMH setting (PeakV)
When the battery type is NiMh, can set the negative
pressure value when the battery is fully charged, the
range is 5mV-15mV, as shown below.
===================================
Tips：
1，Only NiMh battery can set negative battery
voltage.
2，Glossary explanation:
PeakV: When the nickel-metal hydride battery is
fully charged, the voltage drop of each piece peaks.
=================================