M6D Manual V1.0
Table Of Contents
- Introduction
- Key Points
- Further information
- Safety
- Contents
- M6D Layout
- Quick start
- Charge and discharge settings
- 1，Battery type
- 2，Number of cells
- 3，Mode
- 4，Discharge mode
- 5，Input MaxVoltage
- 6，End voltage（TVC）
- 7，Current setting
- 8，NiMH setting (PeakV)
- 9，Cycle setting
- 10，Power mode setting
- 11，Smart battery
- Charge and discharge work
- System settings
- other functions
- Specification
@ ToolkitRC 2020
18
Move the cursor to [Discharge Mode] and press [OK]
to adjust the input MaxVol. If the input voltage reaches
this voltage during discharge, the discharge will stop.
=================================
Tips：
Please set the input cut-off voltage withing the
safe voltage range of the power supply battery. After the
voltage is reached, the charger will automatically stop
recycling and discharging. Setting a high over-voltage
may damage the input power battery.
=================================
6，End voltage（TVC）
Move the cursor to [End Voltage] and press [OK] to
modify the end voltage of the single battery. When the
working mode is charging, it is the charging cut-off