M6D Manual V1.0
Table Of Contents
- Introduction
- Key Points
- Further information
- Safety
- Contents
- M6D Layout
- Quick start
- Charge and discharge settings
- 1，Battery type
- 2，Number of cells
- 3，Mode
- 4，Discharge mode
- 5，Input MaxVoltage
- 6，End voltage（TVC）
- 7，Current setting
- 8，NiMH setting (PeakV)
- 9，Cycle setting
- 10，Power mode setting
- 11，Smart battery
- Charge and discharge work
- System settings
- other functions
- Specification
@ ToolkitRC 2020
15
===================================
Tips
1，Over-discharging or over-charging of the
connected battery may lead to incorrect recognition of
the battery cell number, and it is necessary to manually
set the correct cell number.
2，If the cell number is set incorrectly, it may not
be fully charged, or the battery may be damaged by
overcharging. Please set it carefully.
3，After Lixx battery is connected to the balance
port, the number of battery cells can be more accurately
identified.
===================================
3，Mode
Move the cursor to [Mode] and press [OK] to
modify the working mode, as shown below: