Manual
Table Of Contents
- Introduction
- Key Points
- Safety
- M8SLayout
- Quick start
- Charge and discharge
- 1. Battery type setting
- 2. Cutoff voltage setting（TVC）
- 3. NiMH Setting（PeakV）
- 4. Battery Setting
- 5. Current setting
- 6. Working mode
- Battery Measurement
- ESC Wattmeter
- Signal output
- Power output
- Drone charging
- System settings
- Other functions
- Specification
@
ToolkitRC
2019
8
Quick start
1. The 7-30V power supply is connected to the
input port on the back of the M8S
2. The display shows the bootup logo and stays
for 2 seconds
3. Accompanied with do-re-mi bootup sound
4. the bootup is completed. the display enters
into the main interface as shown below
5. Rotate the [knob]. move the cursor to select
function. press the [OK] button to enter the
selected function and enter the
corresponding interface
6. After entering the related function interface.
Rotate the [knob] to move the cursor to
select the setting item or value. press the [OK]