Manual
Table Of Contents
- Introduction
- Key Points
- Safety
- M8SLayout
- Quick start
- Charge and discharge
- 1. Battery type setting
- 2. Cutoff voltage setting（TVC）
- 3. NiMH Setting（PeakV）
- 4. Battery Setting
- 5. Current setting
- 6. Working mode
- Battery Measurement
- ESC Wattmeter
- Signal output
- Power output
- Drone charging
- System settings
- Other functions
- Specification
@
ToolkitRC
2019
38
Discharge mode: Can be set to normal discharge.
discharged by internal heat dissipation. Or recycle
the discharge and recycle the energy to the input
power source (the input must be rechargeable
battery power) ， Or external mode(need connect
load into the input port)
Idle beep:If the device is not operated during
this time, the sound and light will be
disconnected from the power supply.
SBUS value: The display mode of sBus when
measuring or outputting. can be set to pulse width
value (1000-2000). or original value (0-2047).
Backlight: The brightness level of the backlight of the
display can be set to 1-10
Buzzer: The tone of the buzzer can be set to off.
Energy saving tips: The sound and light are not
disconnected from the power supply during this
time.