Manual
Table Of Contents
- Introduction
- Key Points
- Safety
- M8SLayout
- Quick start
- Charge and discharge
- 1. Battery type setting
- 2. Cutoff voltage setting（TVC）
- 3. NiMH Setting（PeakV）
- 4. Battery Setting
- 5. Current setting
- 6. Working mode
- Battery Measurement
- ESC Wattmeter
- Signal output
- Power output
- Drone charging
- System settings
- Other functions
- Specification
@
ToolkitRC
2019
35
Drone charging
Rotate the [knob] on the [Output] main interface
to move the cursor to the [Power] item. press [OK] to
enter. then move the cursor to the typical value and
change the output mode to the model of the drone
that needs to be charged. Move the cursor to [Start]
and press the enter key. The charger will output the
set voltage. The display interface is as shown below
Typical: For common drone models. it can be set to
the following four types of drones. Mavic2. Mavic.
Phantom. Inspire.
13.0V: The voltage value when the current battery is
full cannot be changed.
3.8AV: Maximum current for charging. adjustable
current.
Start: Start output. stop output button
12.0V 3.0A 36.0W: Voltage. current and power