Manual
Table Of Contents
- Introduction
- Key Points
- Safety
- M8SLayout
- Quick start
- Charge and discharge
- 1. Battery type setting
- 2. Cutoff voltage setting（TVC）
- 3. NiMH Setting（PeakV）
- 4. Battery Setting
- 5. Current setting
- 6. Working mode
- Battery Measurement
- ESC Wattmeter
- Signal output
- Power output
- Drone charging
- System settings
- Other functions
- Specification
@
ToolkitRC
2019
30
Signal output
After selecting the [Output] function on the main
interface press [OK] to enter the function. and the
following interface is displayed.
Rotate the [knob] to move the cursor to the [PWM]
item press [OK] to enter the PWM test interface as
shown below.
Move the cursor to the [Manual] item press [OK] to
set the output mode. which can be set to Manual.