Manual
Table Of Contents
- Introduction
- Key Points
- Safety
- M8SLayout
- Quick start
- Charge and discharge
- 1. Battery type setting
- 2. Cutoff voltage setting（TVC）
- 3. NiMH Setting（PeakV）
- 4. Battery Setting
- 5. Current setting
- 6. Working mode
- Battery Measurement
- ESC Wattmeter
- Signal output
- Power output
- Drone charging
- System settings
- Other functions
- Specification
@
ToolkitRC
2019
27
Move the cursor to [Test] press [OK] once to start
testing the internal resistance. The testing is finished
after about 5 seconds and shows the internal
resistance of the battery
===============================
Tips:
1. This testing needs to charge the battery
for 5A current for a short time. please ensure that
the input power is sufficient and the battery is not
overcharged.
===============================