Manual
Table Of Contents
- Introduction
- Key Points
- Safety
- M8SLayout
- Quick start
- Charge and discharge
- 1. Battery type setting
- 2. Cutoff voltage setting（TVC）
- 3. NiMH Setting（PeakV）
- 4. Battery Setting
- 5. Current setting
- 6. Working mode
- Battery Measurement
- ESC Wattmeter
- Signal output
- Power output
- Drone charging
- System settings
- Other functions
- Specification
@
ToolkitRC
2019
26
Battery Measurement
After selecting [Measurer] function in the main
interface of measurement press [OK] to enter the
function and display the following interface.
This interface displays the current battery voltage
value and range Move the cursor select [Balance]
and press [OK] to start balancing management of
the batteries. Move the cursor to the [Voltage]
position press [OK] to switch to internal resistance
mode and display the following figure.