Manual
Table Of Contents
- Introduction
- Key Points
- Safety
- M8SLayout
- Quick start
- Charge and discharge
- 1. Battery type setting
- 2. Cutoff voltage setting（TVC）
- 3. NiMH Setting（PeakV）
- 4. Battery Setting
- 5. Current setting
- 6. Working mode
- Battery Measurement
- ESC Wattmeter
- Signal output
- Power output
- Drone charging
- System settings
- Other functions
- Specification
@
ToolkitRC
2019
23
Signal measurement
After selecting the [Measurer] function on the
main interface. press [OK] to enter the function and
display the following interface. Press up or down to
select the type of signal to be tested.
Move the cursor to the [PWM] item. press [OK] to
enter the PWM test interface as shown below.
===============================
Tip:
1. PWM and PPM signals can automatically