Manual
Table Of Contents
- Introduction
- Key Points
- Safety
- M8SLayout
- Quick start
- Charge and discharge
- 1. Battery type setting
- 2. Cutoff voltage setting（TVC）
- 3. NiMH Setting（PeakV）
- 4. Battery Setting
- 5. Current setting
- 6. Working mode
- Battery Measurement
- ESC Wattmeter
- Signal output
- Power output
- Drone charging
- System settings
- Other functions
- Specification
@
ToolkitRC
2019
20
Charge and discharge
When charging and discharging starts the charger
enters the working interface as shown below.
Rotate the [knob] key on this screen to switch the
bottom status display information or press and hold
[OK] for 2 seconds to dynamically set the working
current. As shown below
33.20V: The battery voltage of the output port.
10.0A: Charging or discharging current