Manual

4
■
Observe the polarity when making connections (plus pole/+ and minus pole/-). There are
risks of product damage, fire and explosion when making reverse connections.
■
Do not short circuit the charging contacts or connections of the charger to prevent
sparks. Sparks can ignite flammable materials and can cause eye injury or skin burns.
■
Prevent flames and sparks. Keep rechargeable batteries well-ventilated during charging.
Flames and sparks can ignite explosive gases emitted by rechargeable batteries.
4.6.3 Charging
■
Always attend the charging process. There are many hazards associated with charging
rechargeable batteries.
■
Always set the correct charging voltage. Failure to do so may cause a fire or explosion.
■
Always supply the charger with the supported input voltage. Wrong input voltages can
damage the charger or cause fire.
■
Keep the charger well ventilated during operation to allow heat to dissipate. Keep the
ventilation openings unobstructed and clean. Keeping the charger ventilated during oper-
ation reduces the risk of overheating.
4.6.4 After charging
■
Disconnect rechargeable batteries after they are charged. Keeping the work environment
tidy reduces the risk of accidents.
■
Disconnect the charger from the power supply after use to reduce the risk of short cir-
cuits.
4.7 Connected devices
■
Also observe the safety and operating instructions of any other devices which are con-
nected to the product.
5 Technical data
Input voltage ................................. 7 – 28 V/DC
Input current ................................. max. 30 A
Supported battery type ................. LiPo (1-6S) / LiHV (1-6S) / LiFe (1-6S) / Li-ion (1-6S) /
NiMH (1-16S) / Pb (1-10S)
Operating temperature ................. +10 to +40 °C
Operating humidity ....................... 10 - 90 % RH
Storage temperature ..................... -20 to +70 °C
Storage humidity ........................... 10 - 90 % RH
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or the capture in
electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited.
This publication reflects the technical status at the time of printing.
Copyright by Conrad Electronic SE.
*2377697_V1_0921_jh_ss_en I1/O1