Installation Guide

10/06/22 Rev.1.0
9
5.
NOTICE:
See Fig. 7 for details.
NOTE: If the finished opening width is at the
minimum for the model size, attach one wall
profile to the wall, set the door assembly
back into position on the threshold into the
installed wall profile and then attach the
remaining wall profile to the wall.
See Fig. 8 & Fig. 9 for details.
6.
Fig. 7
Fig. 8
1
3
2
6mm
2
1
3
View from inside
2
Fig. 9
1
2
There is adjustment size between fixed
panel(06) and door assembly, the width
can be telescopic based on the exact
request.
Once confirmed the width, adjust the level, and then fix the
wall jamb(02) on the wall.
1)Place the wall jamb(02) into the correct position and
mark the position of punch, using 6mm drill to punch.
2)Using the wall plugs (01) and screws ST4x35(03)
to secure them to the wall.
Adjust the maximum size 36’’(914mm),
minimum size 32’’(813)
2
6