Installation Guide

6.
Assembly
Position the template against the wall. Use
a spirit level. Mark the wall with a pencil
through the holes in the template.
Mount the holder by hooking the top in a 45°
angle. Push downwards until a click sound is
heard. Error when pressure mounting.
Lock the lid at the bottom. A click sound is
heard when the lid is properly shut. Error if
the lid is not over the heel.
The release tab shall face down. Error
when facing upwards.
Secure the plastic mounting brackets on
each of the marked points on the wall.
Align the rail to the brackets.
Lock the lid by hooking the top piece with
the release tab facing down. Push down-
wards. Error when pressure mounting.
1.
5.4.
2.
Max 48 cm
3.
Dismantling
1. 2.
Remove all tools before releasing the
lids.
All lids must be loosened before removing
the rail
For more instructions on how to install Toolflex One, please visit
toolflex.com/professional/
If you have any questions, please contact [e-mail]