Instructions
34
13. Troubleshooting
Before taking measures to eliminate faults rst make sure the device is powered off. The mains plug should
be disconnected from mains socket and the motor unit should have completely cooled down.
Cause Solution
The product will not
switch on.
• Check if the mains plug is correctly connected. Disconnect the power plug from the
power outlet and plug it back in after 10 seconds.
• Make sure the power outlet is live. Connect another appliance to the same outlet. If this
appliance will not switch on, consult an electrician.
Poor suction power
• Check if the lter is dirty and clean if necessary.
• Check if the tube, hose or the nozzles are clogged.
• Empty the container if full.
Dust comes out of
the air outlet
• Check if the correct lter is inserted or if it is damaged. If necessary, reinstall the
cartridge lter or replace it.
• Particles are too ne to be captured by the lter. Stop vacuuming the material.
Motor is unusually
loud.
• Immediately stop operation of the device.
• Check if the tube, hose or the nozzles are clogged or if the container is full.
• If the problem persists, switch the device off. Disconnect the mains plug and contact
a specialist.
14. Spare Parts
Spare parts can be purchased online at www.conrad.com. Search for them using item numbers. The following parts
are currently available:
Item No. Part
2102065 Cartridge lter
2102066 Foam sleeve
15. Disposal
Electronic devices are recyclable waste and must not be placed in household waste. At the end of its
service life, dispose of the product according to the relevant statutory regulations. You thus fulll your
statutory obligations and contribute to protection of the environment.